Complete Electronics Hardware Design Course 2021 -EsteemPCB

Use Coupon Code "JULY_90OFF" to get ~90% off on total course price (Valid for Today only)

Instructor:

Aviral Mishra

1,580 students enrolled

How to Extract Components information from Requirement Sheet

Selection of Component for Example: Ethernet PHY, Micro-Controller, Motor Driver, Mosfets, ADC, ADC/DAC, MIC etc.

How to Draw a Complex Schematic Block and Its Power Budget Diagrams

What are Differential pairs, USB2.0, I2Cs, UART/USART, CAN, MII/RMII, I2S and many more interfaces

EMI & EMC decisions for a Complex Mixed Signal Schematic Design

How to Create Design Rules Decision for Complex Mixed Signal Board

Layer Stack-Up Design (4L/6L/8L/12L) and Field Solver Simulation

How to Define Board shape and Rigid-Flex PCB Board

Components Placement planning for a Complex Board and its Execution

How to Layout a Complex Board with more than 10,000 interconnects, and Layout Optimization

Power Distribution Network (PDN Analysis) and How to read its Report + Resolve Issues

Complex Mixed Signal Board Design Course (Ethernet PHY, STM32F407, STM32F103, CH340C, DAC/MIC, 24Bit ADC, 36W Drivers)

I have Divided this course into 4 Major Sections:

1st Section is Selection of Each Components whatever Going inside the Schematic.
2nd Section is Schematic Designing by Reading Datasheets.
3rd Stack-up 4L/6L/8L/12L, Components Placement Planning and Execution.
4th Inter Block and Intra Block Layout Planning and Execution.

Major Schematic Blocks that I have designed in this course are “Ethernet PHY 10/100 Mb/s”, “I2S DAC for Headphone and Speaker”, “MEMS MIC”, “24BIT ADC”, “36W Bi-Directional Brushed DC Motor Divers”, “UART to USB TTL Converter”, “STM32F103 Controller as Debugger and Programmer”, “STM32F407 Main Controller”, “Power Supply and Protections” and many more…. Various Subparts as you can see from the Curriculum.

You will also learn some Basic Blocks as well:

Pre-Schematic Design Blocks (Block Diagram and Power Budget)
Layer Stack-up Selection and Rules for Defining any Stack-up
Different Grounding Techniques( Signal Grounding, Earth Grounding, Chassis Grounding)
How to Create a RIGID-FLEX PCB and its Stack-up
How to do Pin-mapping using Cube-MX tool.
Power Distribution Network Analysis (PDN Analysis) of any PCB.

and many more things.
Ferrite Bead, ESD Diodes, and Magnetic Application and their selection.
How to do Placement and Layout Planning on Microsoft-Paint.

and many more….

After the completion of this course you can design any “Mixed Signal with Micro-Controller available across the world”.

Major Controller used in this course are STM32F407XX, STM32F103XX apart from that we used PHY, and Some other sensors and ADC/ DAC as well.

How long do I have access to the course materials?

You can view and review the lecture materials indefinitely, like an on-demand channel.

Can I take my courses with me wherever I go?

Definitely! If you have an internet connection, courses on Udemy are available on any device at any time. If you don't have an internet connection, some instructors also let their students download course lectures. That's up to the instructor though, so make sure you get on their good side!

4.3

4.3 out of 5

246 Ratings